By the time this is published, the 2009 Engine Masters Challenge (EMC) will be history and the final results very likely posted all over the internet. Because this is being written as the engine is still being tested and before the competition takes place, I’ll do a followup article on the actual competition and what took place there. But in the meantime, here’s the short version of what was involved to get a Ford Y-Block engine readied for the EMC competition. Continue reading “Preparing a 375 inch Y-Block Ford for the 2009 EMC Competition.”
Month: March 2010
A Y-Block at the 2009 Engine Masters Challenge
The 2009 EMC competition is now history. The Y engine that was taken to the competition was the 375 inch version that was far from being a reality when September 1st rolled around. The 4” crank and 6.750” long rods from the previously wounded 4″X4″ Y engine were used in the 375 incher along with the cam and lifters. Continue reading “A Y-Block at the 2009 Engine Masters Challenge”